Latest activity

Just watched it. For the backside he used the actual rail as the guide against the flat side of the router base - I knew it was less...

@friedchicken You should be able to do the reverse the guide on the back of the rail with the Festool attachment. This pic is using an...

I have occasionally fed NM into conduit for a drop, but I usually put in a junction box and run individual wire. The last one I put in...

I went to Lowes last week and bought two small packages of epoxy. Both were hanging on the same peg board hood. Both shared the same...

This doesn't appear to be working in some cases. It appears to be pulling user name over instead of email address. Since my user name...

You can also mount the guide stop on the guide rail backwards and cut on the back side iirc. It is a bit more clunky and but was...

That's what's nice about the Micro Fence, you can work off of the other side of the rail.

Nah... I didn't notice either. But then again, I cannot always tell if someone is under the influence.

"The best predictor of future behavior is ... past behavior." - Dr. Phil McGraw

I have always hung my rails vertically. Why else would they put the hole at the end? I never once considered the ramifications of the...

I’ll have to check when I bought it to see if it is still within the 3 year warranty period. Also the nearest Festool dealer is a...

Wouldn't help in this instance, because the photo shows there's nothing for the "foot" to rest upon.

OF2200 has a baseplate that straddles the rail for this case...

1. they don't include this anymore, although I did furnish one. 2. There's a reason I want to use the guide rail

I just treat it the same as any blade unless going through thicker materials, With thicker materials I make a couple of passes as I know...